Engine |
Tractor Type |
KM800 KM804 |
KM1000 KM1004 |
Engine Type |
226B-4T2 |
226B-4T3 |
Feature |
4 Cylinder,4 Stroke,Water cooling,Straight line,,Direct injection,Natural Aspiration |
4 Cylinder,4 Stroke,Water cooling,Straight line,,Direct injection,Pressure increasing |
Cylinder Number |
4 |
Bore*Stroke(mm) |
105*120 |
Rated revolution(r/min) |
2400 |
Max Torque(N.M) |
270 |
351 |
Rated power(KW) |
59 |
73.5 |
Fuel consumption(g/kw.h)(Rated working conditions) |
≤230 |
≤225 |
Engine oil conditions(g/kw.h) |
≤1.36 |
Lubricating Method |
Pressure and splash lubricating |
Cooling Method |
Forced circulating water cooling |
Transmission System |
Clutch |
Dry type Double disk independent operation 2stage |
Transmission Box |
18 forward gear、6 reverse gear(normal),27 forward gear、9 reverse gear(Equipped with creeper) |
Brake Assembly |
Foot-controlled、hydraulic operating、single disk |
Working Device |
Constructional weight(kg) |
3740(KM800);3940(KM804); 3800KM1000);4000(KM1004) |
Rated traction force(KN) |
18(KM800);22(KM800); 20(KM1000);24(KM1004) |
Front type |
7.50~20(KM800)
11.2~28(KM804) |
7.50~20(KM1000)
12.4~28(KM1004) |
Rear type |
16.9~34 |
16.9~38 |
Front wheel Tread |
1470~1970(KM800 KM1000) 1630~1960(KM804 KM1004) |
Rear Wheel Tread |
1504~2074 |
Wheel Base |
2395(KM800 KM1000 ) 2385(KM804 KM1004) |
Steering System |
Steering Type |
Full Hydraulic Steering |
Minimum |
Single brake |
3.3(KM800));3.6(KM804); 3.3(KM1000));3.65(KM1004) |
Turning radius |
Non-single brake |
4(KM800);4.3(KM804) 4 (KM1000));4.3(KM1004) |
Working Device |
Lifter |
Max.Lifting Capacity(KN) |
≥22,drive one additional oil cylinder |
≥25,drive two additional oil cylinder |
Tilling depth control |
Draft and position responsive,Comprehensive responsive,Floating responsive |
Opening pressure of Safty valve |
19 |
Hydraulic oil pump |
Gear pump CBF-316 |
Hydraulic take-off |
Norminal pressure |
19 |
Norminal flow capacity |
45 |
P.T.O. |
Type |
Independent and synchronous P.T.O. |
Revolution(r/min) |
Independent Type:540&1000 Ratio of synchronous P.T.O.& driving wheel |
Spline shaft Dimension |
II Type 21 gears gradual opening line spline(1000r/min)EXT21ZX1.5875m30P or 8 gears rectangle spline(540r/min)8d*41.6-0.3º*47.2±0.1*8-0.25-0.15 |